Buchi Vacuum Controller V-855 Bedienungsanleitung PDF herunterladen (Seite 22)

5 Putting into operation

22 V-850/855 Operation Manual, Version E

5.3 Installing the AutoDest probe

To install the AutoDest probe proceed as follows:

• Insert the AutoDest probe into the opening at the top of the condenser.

• Push the probe down between the inner condenser coil and the vacuum tube in the center of the

condenser.

• Position the probe as shown in Fig. 5.3. Make sure that the prope tip position corresponds to posi-

tion a in Fig. 5.3.

• Tightened screw cap at the top of the condenser.

• Plug the cable of the AutoDest probe into the AS/SB socket of the controller (position b in the

ﬁgure above).

NOTE:

Calibrate the AutoDest probe, see also chapter 6.7.5.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Keine Kommentare

Buchi Vacuum Controller V-855 Bedienungsanleitung Seite 22